FAG HS71917-C-T-P4S Angular contact ball bearings
Also known as : HS71917-C-T-P4S
- Inside Diameter: 85 mm
- Outside Diameter: 120 mm
- Width: 18 mm
- Basic dynamic load rating: 21.2 kN
- Basic static load rating: 17 kN
FAG HS71917-C-T-P4S
FAG HS71917-C-T-P4S details
| Number | HS71917-C-T-P4S | |
|---|---|---|
| Type | FAG spindle bearings adjusted, in pairs or sets, contact angle a = 15°, restricted tolerances | |
| d | 85 mm | |
| D | 120 mm | |
| B | 18 mm | |
| a | 22,7 mm | |
| Da | 114 mm | Tolerance: H12 |
| da | 92 mm | Tolerance: h12 |
| Etk max | 99,9 mm | |
| Etk min | 98,5 mm | |
| Etk1 max | 99,9 mm | |
| Etk1 min | 96 mm | |
| r1 min | 1,1 mm | |
| ra max | 0,6 mm | |
| ra1 max | 0,6 mm | |
| rmin | 1,1 mm | |
| α | 15 ° | Contact angle |
| m | 0,572 kg | ≈ Mass |
| Cr | 21200 N | Basic dynamic load rating, radial |
| C0r | 17000 N | Basic static load rating, radial |
| Cur | 1720 N | Fatigue limit load, radial |
| nG Fett | 15000 1/min | Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 24000 1/min | Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 74 N | Preload force |
| FV M | 221 N | Preload force |
| FV H | 442 N | Preload force |
| KaE L | 220 N | Lift-off force |
| KaE M | 689 N | Lift-off force |
| KaE H | 1433 N | Lift-off force |
| ca L | 55,9 N/µm | Axial rigidity |
| ca M | 87,4 N/µm | Axial rigidity |
| ca H | 119 N/µm | Axial rigidity |
FAG HS71917-C-T-P4S bearing cross reference
30/5-B-2Z-TVH
85 mmx 120 mmx 18 mm
3806-B-2RS-TVH
85 mmx 120 mmx 18 mm
3801-B-2RS-TVH
85 mmx 120 mmx 18 mm
3217-B-2RS-TVH
85 mmx 120 mmx 18 mm
3313-BD-XL
85 mmx 120 mmx 18 mm
3311-BD-XL
85 mmx 120 mmx 18 mm
3310-BD-XL-TVH
85 mmx 120 mmx 18 mm
3310-BD-XL
85 mmx 120 mmx 18 mm
3309-BD-XL
85 mmx 120 mmx 18 mm
3307-BD-XL
85 mmx 120 mmx 18 mm
3306-BD-XL
85 mmx 120 mmx 18 mm
