FAG HS71914-C-T-P4S Angular contact ball bearings
Also known as : HS71914-C-T-P4S
- Inside Diameter: 70 mm
- Outside Diameter: 100 mm
- Width: 16 mm
- Basic dynamic load rating: 17.8 kN
- Basic static load rating: 12.9 kN
FAG HS71914-C-T-P4S
FAG HS71914-C-T-P4S details
| Number | HS71914-C-T-P4S | |
|---|---|---|
| Type |
FAG spindle bearings adjusted, in pairs or sets, contact angle a = 15°, restricted tolerances |
|
| d | 70 mm | |
| D | 100 mm | |
| B | 16 mm | |
| a | 19,4 mm | |
| Da | 94,5 mm | Tolerance: H12 |
| da | 76 mm | Tolerance: h12 |
| Etk max | 82,6 mm | |
| Etk min | 81,2 mm | |
| Etk1 max | 82,6 mm | |
| Etk1 min | 78,8 mm | |
| r1 min | 1 mm | |
| ra max | 0,6 mm | |
| ra1 max | 0,3 mm | |
| rmin | 1 mm | |
| α | 15 ° | Contact angle |
| m | 0,354 kg | ≈ Mass |
| Cr | 17800 N | Basic dynamic load rating, radial |
| C0r | 12900 N | Basic static load rating, radial |
| Cur | 1330 N | Fatigue limit load, radial |
| nG Fett | 19000 1/min |
Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings. |
| nG Öl | 28000 1/min |
Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings. |
| FV L | 61 N | Preload force |
| FV M | 184 N | Preload force |
| FV H | 368 N | Preload force |
| KaE L | 183 N | Lift-off force |
| KaE M | 576 N | Lift-off force |
| KaE H | 1198 N | Lift-off force |
| ca L | 47 N/µm | Axial rigidity |
| ca M | 73,7 N/µm | Axial rigidity |
| ca H | 101 N/µm | Axial rigidity |
FAG HS71914-C-T-P4S bearing cross reference
30/5-B-2Z-TVH
70 mmx 100 mmx 16 mm
3806-B-2RS-TVH
70 mmx 100 mmx 16 mm
3801-B-2RS-TVH
70 mmx 100 mmx 16 mm
3217-B-2RS-TVH
70 mmx 100 mmx 16 mm
3313-BD-XL
70 mmx 100 mmx 16 mm
3311-BD-XL
70 mmx 100 mmx 16 mm
3310-BD-XL-TVH
70 mmx 100 mmx 16 mm
3310-BD-XL
70 mmx 100 mmx 16 mm
3309-BD-XL
70 mmx 100 mmx 16 mm
3307-BD-XL
70 mmx 100 mmx 16 mm
3306-BD-XL
70 mmx 100 mmx 16 mm
